Neutrik Accessories
Neutrik accessories are connectors, adaptors and couplers from Liechtenstein that you buy when soldering your own cables or building a patch panel. Most are XLR connectors for cable and panel mounting, alongside BNC, jack, speakON, powerCON and etherCON. Neutrik is the manufacturer that developed speakON, powerCON and etherCON, and you will find its connectors on stages, in studios and in PA equipment. The other large group consists of connector accessories that you buy to go with a connector you have already chosen.
How do you read Neutrik connector codes?
A Neutrik code tells you the connector type, number of poles and gender. The prefix NC means a cable XLR, NP means a jack, NL means speakON and NA means an adaptor. The digit after the prefix gives the number of poles, while M means male and F means female. For example, NC3MXX is a three-pole male cable XLR, NC3FXX a three-pole female XLR, NP2X a two-pole (mono) jack and NP3X a three-pole (stereo) 6.3 mm jack.
- XLR: microphones, line-level and DMX connections, with different numbers of poles.
- speakON: amplifier to passive speaker, with a lock to prevent accidental disconnection.
- powerCON: power supply to equipment, not an audio signal.
Cable connector or panel connector?
A cable connector terminates a cable and must match its diameter when you choose it. A panel connector screws into a panel, stagebox or equipment enclosure, and the size of the mounting hole determines your choice. If you run the cable close alongside equipment, a right-angle version helps, such as the NP2RX jack. Ready-made cables and other connections are on the Neutrik Cables, Connectors and Adapters page.
When should you choose a Neutrik adaptor?
A Neutrik adaptor joins two different connectors or two connectors of the same gender, such as the two female XLR connectors in the NA3FF. The range includes XLR-XLR, jack-XLR, XLR-RCA and XLR-speakON adaptors. An adaptor only provides the mechanical connection: it will not turn a microphone signal into a line-level signal, and it will only convert a balanced output to unbalanced with the correct pole wiring.
